Installation instructions
Any electrical and/or plumbing work required to install
Water supply connections
this appliance should be carried out by a qualifiedThis dishwasher must be plumbed into a cold water supply.
electrician and/or plumber or competent person.
Remove all packaging before positioning the machine.For making the connection itself, the coupling nut fitted to the
machineOs supply hose is designed to screw onto a 3/4" inch
If possible, position the machine next to a water tap and agas thread spout.
drain.
The water pressure must be within the limits given in the
"Technical specifications". Your local Water Authority will
advise you on the average mains pressure in your area.
Fitting under a counter The water inlet hose must not be kinked, crushed, or entangled
(kitchen worktop or sink)when it is being connected.
By removing the machineOs worktop, you can install it under aThe inlet hose must hang down vertically from the supply tap.
close fitting sink unit or a pre-existing top, providing theThe dishwasher features fill and drain hoses which can be
dimensions of the recess correspond to those shown in theturned either to the left or the right to suit the installation by
picture.means of the locknut. The locknut must be correctly fitted
to avoid water leaks. (Attention! NOTall models of
dishwashers have fill and drain hoses provided with locknut. In
this case, this kind of facility is not possible).
570-600
If the machine is connected to new pipes or pipes which have
not been used for a long time, you should run the water for a
few minutes before connecting the inlet hose. 820
Do not use, for connection, old hoses which have been
450used with another appliance.
The dishwasher is fitted with safety devices that prevent the
wash water returning into the drinking water system and
comply with the applicable plumbing regulations.IN04
Proceed as follows:
Remove the machineOs worktop by unscrewing the two rear
retaining screws, pull the worktop from the back of the
machine and slide out the front slots, lifting the worktop.
Insert the machine after adjusting height and levelling with the
adjustable feet. When inserting the machine, ensure that the
water inlet and drain hoses are not kinked or squashed.
During all operations that involve accessibility to internal
components the dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily
accessible for the service engineer in the event that a repair is
required.
If the dishwasher is later used as a free-standing appliance,
the original worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not catch
on either side of the cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
17 |
ACEC
